H3C Technologies H3C S7500E Series Switches - Manual (Page 67)

3-28
To do… Use the command… Remarks
Enter one or more VTY user
interface views
user-interface vty first-number
[ last-number ]
—
Specify the scheme authentication
mode
authentication-mode scheme
Required
By default, authentication mode for
VTY user interfaces is password.
Enable the current user interface
to support either Telnet, SSH, or
both of them
protocol inbound { all | ssh }
Optional
By default, both protocols are
supported.
Create a local user and enter local
user view
local-user user-name
Required
By default, no local user exists.
Set the local password
password { cipher | simple }
password
Required
By default, no local password is
set.
Specifies the command level of the
local user
authorization-attribute level level
Optional
By default, the command level is 0.
Specify the service type for the
local user
service-type ssh
Required
By default, no service type is
specified.
Return to system view quit —
Create an SSH user, and specify
the authentication mode for the
SSH user
ssh user username service-type
stelnet authentication-type
{ password | { any |
password-publickey |
publickey } assign publickey
keyname }
Required
By default, no SSH user exists,
and no authentication mode is
specified.
Configure common settings for
VTY user interfaces
—
Optional
See Configuring Common Settings
for VTY User Interfaces (Optional) .
For more information about SSH, see SSH2.0 Configuration in the Security Configuration Guide.