H3C Technologies H3C S7500E Series Switches - Manual (Page 287)

8-7
To do… Use the command… Remarks
Enter system view system-view —
Enter RIPng view ripng [ process-id ] —
Configure a RIPng priority
preference [ route-policy
route-policy-name ] preference
Optional
By default, the RIPng priority is
100.
Configuring RIPng Route Redistribution
Follow these steps to configure RIPng route redistribution:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIPng view ripng [ process-id ] ––
Configure a default routing metric
for redistributed routes
default cost cost
Optional
The default metric of redistributed
routes is 0.
Redistribute routes from another
routing protocol
import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | route-policy
route-policy-name ] *
Required
No route redistribution is
configured by default.
Tuning and Optimizing the RIPng Network
This section describes how to tune and optimize the performance of the RIPng network as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
z Configure a network layer address for each interface
z Configure the basic RIPng functions
This section covers the following topics:
z Configuring RIPng Timers
z Configuring Split Horizon and Poison Reverse
z Configuring Zero Field Check on RIPng Packets
z Configuring the Maximum Number of Equal Cost Routes for Load Balancing
Configuring RIPng Timers
You can adjust RIPng timers to optimize the performance of the RIPng network.
Follow these steps to configure RIPng timers: