H3C Technologies H3C S3600 Series Switches - Manual (Page 965)

1-18
To do… Use the command… Remarks
Display the source IP address
used by the current SFTP client
display sftp source-ip
Optional
Available in any view
SFTP Configuration Example
Network requirements
As shown in Figure 1-7 , establish an SSH connection between the SFTP client (switch A) and the SFTP
server (switch B). Log in to switch B through switch A to manage and transmit files. An SFTP user with
the username client001 and password abc exists on the SFTP server.
Network diagram
Figure 1-7 Network diagram for SFTP configuration
Configuration procedure
1) Configure the SFTP server (switch B)
# Create key pairs.
<Sysname> system-view
[Sysname] public-key local create rsa
[Sysname] public-key local create dsa
# Create a VLAN interface on the switch and assign to it an IP address, which is used as the destination
address for the client to connect to the SFTP server.
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ip address 192.168.0.1 255.255.255.0
[Sysname-Vlan-interface1] quit
# Specify the SSH authentication mode as AAA.
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] authentication-mode scheme
# Configure the protocol through which the remote user logs in to the switch as SSH.
[Sysname-ui-vty0-4] protocol inbound ssh
[Sysname-ui-vty0-4] quit
# Create a local user client001.
[Sysname] local-user client001
[Sysname-luser-client001] password simple abc
[Sysname-luser-client001] service-type ssh
[Sysname-luser-client001] quit
# Configure the authentication mode as password. Authentication timeout time, retry number, and
update time of the server key adopt the default values.