H3C Technologies H3C SR8800 - Manual (Page 59)

51
3. Verify the configuration:
Use the display interface hdlc-bundle command on Router A or Router B to verify that the state of
HDLC link bundle interface 1 is UP.
Take the output on Router A for example.
[RouterA] display interface Hdlc-bundle 1
Hdlc-bundle1 current state: UP
Line protocol current state: UP
Description: Hdlc-bundle1 Interface
The Maximum Transmit Unit is 1500
Internet Address is 1.1.1.1/24 Primary
Link layer protocol is HDLC
Physical is HDLC-BUNDLE, baudrate: 155520 kbps
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Verify that the HDLC link bundle interfaces on Router A and Router B can ping each other.
[RouterA] ping –a 1.1.1.1 1.1.1.2
PING 1.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 1.1.1.2: bytes=56 Sequence=1 ttl=255 time=6 ms
Reply from 1.1.1.2: bytes=56 Sequence=2 ttl=255 time=3 ms
Reply from 1.1.1.2: bytes=56 Sequence=3 ttl=255 time=3 ms
Reply from 1.1.1.2: bytes=56 Sequence=4 ttl=255 time=3 ms
Reply from 1.1.1.2: bytes=56 Sequence=5 ttl=255 time=3 ms
--- 1.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/3/6 ms