Configuring dce side frame relay, Configuring basic dce side frame relay, Configuring frame relay address mapping – H3C Technologies H3C SR8800 User Manual
Page 67: Configuring frame relay local virtual circuit
59
Step Command
Remarks
4.
Configure address mapping.
See “
.”
Optional.
For a P2MP subinterface, you must
set up an address map.
Configuring DCE side frame relay
Configuring basic DCE side frame relay
To configure DCE side frame relay:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure interface
encapsulation protocol as
frame relay.
link-protocol fr [ ietf |
nonstandard ]
The link layer protocol for interface
encapsulation is PPP by default.
When frame relay is configured as
the link layer protocol, the
encapsulation format is defaulted
to IETF.
4.
Configure the frame relay
interface type to DCE.
fr interface-type dce
Optional.
The default frame relay interface
type is DTE.
5.
Configure the frame relay LMI
protocol type.
fr lmi type { ansi | nonstandard |
q933a }
Optional.
The default frame relay LMI
protocol type is q933a.
6.
Configure network side
N392.
fr lmi n392dce n392-value
Optional.
The default value is 3.
7.
Configure network side
N393.
fr lmi n393dce n393-value
Optional.
The default value is 4.
8.
Configure network side T392. fr lmi t392dce t392-value
Optional.
The default value is 15 seconds.
Configuring frame relay address mapping
See “
Configuring frame relay address mappings
.”
Configuring frame relay local virtual circuit
See “