H3C Technologies H3C MSR 50 - Manual (Page 94)

Complete the following tasks to configure CWMP at the CLI:
Task Remarks
Enabling CWMP Required.
Configuring ACS attributes:
Required.
• Configuring the ACS URL
Supports configuration through ACS,
DHCP, and CLI.
Optional.
• Configuring the ACS username and password
Supports configuration through ACS,
DHCP, and CLI.
Configuring CPE attributes:
Optional.
• Configuring the CPE username and password
Supports configuration through ACS and
CLI.
Optional.
• Configuring the CWMP connection interface
Supports configuration through CLI only.
Optional.
• Sending Inform messages
Supports configuration through ACS and
CLI.
Optional. • Configuring the maximum number of attempts made to retry a
connection
Supports configuration through CLI only.
Optional.
• Configuring the close-wait timer of the CPE
Supports configuration through CLI only.
Optional.
• Configuring the CPE working mode
Supports configuration through CLI only.
Optional.
• Specifying an SSL client policy for HTTPS connection to ACS
Supports configuration through CLI only.
Enabling CWMP
CWMP configurations can take effect only after you enable CWMP.
To enable CWMP:
Step Command Remarks
176. Enter system view. system-view N/A
177. Enter CWMP view. cwmp N/A
178. Enable CWMP. cwmp enable By default, CWMP is disabled.
81