H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 118)

108
Step Command Remarks
14. Disable PPP log displaying. pppoe-server log-information off
Optional.
Enabled by default.
NOTE:
When configuring a static route on a VT interface, specify the next hop instead of the outgoing interface.
If the outgoing interface is required, make sure that the physical interface bound to the virtual template is
effective to ensure normal transport of packets.
Displaying and maintaining PPPoE
Task Command Remarks
Display the statistics and state
information about a PPPoE server.
display pppoe-server session { all |
packet } [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Terminate a PPPoE session on a
PPPoE server.
reset pppoe-server { all | interface
interface-type interface-number |
virtual-template number }
Available in any view.
PPPoE server configuration example
Network requirements
In Figure 28 , Clients 1, 2, and, 3 (PPPoE clients), access the Internet through AC (PPPoE server), which
performs local authentication and assigns IP addresses to the users.
AC provides Internet access for PPPoE clients through VLAN-interface 1. It connects to the Internet through
VLAN-interface 2.
Figure 28 Network diagram
Configuration procedure
• Configure CHAP authentication:
# Add a PPPoE user.
<AC> system-view
Internet
AC
AP 1
AP 3
L2 switch
Client 1
AP 2 Client 2
Client 3