H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 66)

56
• If the configuration BPDU received on a designated port has a lower priority than the configuration
BPDU of the local port, the port immediately sends out its own configuration BPDU in response.
• If a path becomes faulty, the root port on this path no longer receives new configuration BPDUs and
the old configuration BPDUs are discarded due to timeout. The device generates a configuration
BPDU with itself as the root and sends out the BPDUs and TCN BPDUs. This triggers a new spanning
tree calculation process to establish a new path to restore the network connectivity.
However, the newly calculated configuration BPDU cannot be propagated throughout the network
immediately, so the old root ports and designated ports that have not detected the topology change
continue forwarding data along the old path. If the new root ports and designated ports begin to
forward data as soon as they are elected, a temporary loop may occur.
STP timers
STP calculation involves the following timers: forward delay, hello time, and max age.
• Forward delay
Forward delay is the delay time for state transition.
A path failure can cause spanning tree re-calculation to adapt the spanning tree structure to the
change. However, the resulting new configuration BPDU cannot propagate throughout the
network immediately. If the newly elected root ports and designated ports start to forward data
right away, a temporary loop is likely to occur.
For this reason, as a mechanism for state transition in STP, the newly elected root ports or
designated ports require twice the forward delay time before transiting to the forwarding state to
make sure that the new configuration BPDU has propagated throughout the network.
• Hello time
The device sends hello packets at the hello time interval to the neighboring devices to make sure
that the paths are fault-free.
• Max age
The device uses the max age to determine whether a stored configuration BPDU has expired and
discards it if the max age is exceeded.
RSTP
Developed based on the 802.1w standard of IEEE, RSTP is an optimized version of STP. It achieves rapid
network convergence by allowing a newly elected root port or designated port to enter the forwarding
state much quicker under certain conditions than in STP.
A newly elected RSTP root port rapidly enters the forwarding state if the old root port on the device has
stopped forwarding data and the upstream designated port has started forwarding data.
A newly elected RSTP designated port rapidly enters the forwarding state if it is an edge port (which
directly connects to a user terminal rather than to another device or a shared LAN segment) or it connects
to a point-to-point link (to another device). Edge ports directly enter the forwarding state. Connecting to
a point-to-point link, a designated port enters the forwarding state immediately after the device receives
a handshake response from the directly connected device.