H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 93)

85
• A remote probe VLAN must be a static VLAN. To remove the VLAN configured as a remote probe
VLAN, you must first remove the remote probe VLAN with the undo mirroring-group remote-probe
vlan command.
• If the remote probe VLAN of a remote mirroring group is removed, the remote mirroring group will
become invalid.
• The link type of monitor ports configured for port mirroring must be access.
Configuration procedure
To configure local port mirroring with multiple monitor ports:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a remote source
mirroring group.
mirroring-group group-id
remote-source By default, no mirroring group exists
on a device.
3. Configure source ports
for the remote source
mirroring group.
• (Method 1) In system view:
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
• (Method 2) In interface view:
a. interface interface-type
interface-number
b. [ mirroring-group group-id ]
mirroring-port { both |
inbound | outbound }
c. quit
Use either method.
By default, no source port is
configured for a mirroring group.
4. Configure the reflector
port for the remote
source mirroring group.
mirroring-group group-id reflector-port
reflector-port By default, no reflector port is
configured for a mirroring group.
5. Create the remote
probe VLAN and enter
VLAN view.
vlan vlan-id
By default, no remote probe VLAN is
configured for a mirroring group.
6. Assign monitor ports to
the remote probe
VLAN.
port interface-list
By default, a newly-created VLAN
does not have any member port.
7. Return to system view. quit N/A
8. Configure the remote
probe VLAN for the
remote source mirroring
group.
mirroring-group group-id
remote-probe vlan rprobe-vlan-id By default, no remote probe VLAN is
configured for a mirroring group.
Configuring Layer 2 remote port mirroring
This section describes the Layer 2 remote port mirroring configuration procedures.