H3C Technologies H3C SecBlade IPS Cards - Manual (Page 33)

26
Figure 15 Connectivity test result
# Configure security zones.
After completing OAA configuration on the SecBlade IPS card and the S7500E, you can add any
physical ports of the S7500E to a security zone except the internal interface.
In this example, create internal security zone Inside and add GigabitEthernet 3/0/1 and
GigabitEthernet 3/0/2 to the internal security zone, as shown in Figure 16 . Create external security zone
Outside and add GigabitEthernet 3/0/20 to the external security zone in the same way.
Figure 16 Create a security zone
# Configure a segment.
Figure 17 Create a segment
NOTE:
When creating a segment, you need to select the internal zone, external zone and the internal interface.