H3C Technologies H3C SecBlade IPS Cards - Manual (Page 74)

67
• Configure the OAA client and the internal interface and test the connectivity between the OAA
client and the router.
Figure 47 Configure the OAA client
After completing configuration, click Test Connectivity. If the following message appears, the router is
reachable.
Figure 48 Connectivity test result
# Configure security zones.
After completing OAA configuration on the SecBlade IPS card and the router, you can add any physical
ports of the router except the internal interface to a security zone.
In this example, create internal security zone Inside add GigabitEthernet 1/0/1 and GigabitEthernet
1/0/2 to the internal zone, as shown in Figure 49 . Create external security zone Outside and add
GigabitEthernet 1/0/3 to the external zone in the same way.