Grass Valley 2010RDA-16 User Manual
Page 10
10
2010RDA-16 Instruction Manual
Installation
2.
Insert the passive rear module into vacant rear slot 2, 4, 6, 8, 10, or 12 of
the frame as illustrated in
Figure 3. Installing Passive Rear Module
3.
Verify that the module connector seats properly against the midplane.
4.
Using a crossblade screwdriver, tighten
the four screw locks to secure
the module in the frame.
5.
Locate the front slot 2, 4, 6, 8, 10, or 12 in the frame corresponding to the
rear module circuit board. The 3 RU frame front view is illustrated in
. Module slots for the 2010RDA-16 are highlighted in gray.
Figure 4. 2000 Series 3 RU Frame, Front Slots
2010RDA-16 Passive Rear Module
2010
RDA-16
Alignment post
and receptacle
Screw locks
(both sides)
8268_03
2000 frame (rear view)
Board edge guides
(both sides)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(1)
Install Front Media modules
into slots 2, 4, 6, 8, 10, and 12.
8268_01