Grass Valley 2030RDA - Manual (Page 12)

12 2030RDA Instruction Manual
Power Up
Power Up
The front LED indicators and configuration switches are illustrated in
Figure 8 . Upon power-up, the green PWR LED should light and the yellow
CONF LED should illuminate for the duration of module initialization.
Operation Indicator LEDs
With factory default configuration and a valid input signal connected, the
green PWR LED, the green Signal present LEDs and the detected signal
data rate LED should be on. Refer to
Table 1 on page 13 to see a complete
list of possible operating conditions and the resulting indicator status.
Figure 8. LEDs and Configuration Switches
8031_01
FAULT (red)
COMM (yellow)
CONF (yellow)
PWR (green)
Signal present (green)
Note:
A Signal Present LED is also
present on the connector plate
of the Passive Rear Module
Bypass (yellow)
143 Mb (yellow)
177 Mb (yellow)
270 Mb (yellow)
360 Mb (yellow)
Remote Override
(yellow)