Ericsson A1228LX - Manual (Page 11)

Not for commercial use – Ericsson Inc.
8 Getting Started
Connecting and Removing Your Battery
 Place the battery over the back of
the phone. The label on the bat-
tery should face down. Insert the
top portion of the battery into the
phone. The tab on the bottom of
the battery should be pointing
toward the bottom of the phone.
 Press down until you hear a click.
The battery is now connected.
 Remove the battery by pushing in
on the tab of the battery with your
thumb.
 Then, lift the battery up and out of
the battery cavity.
Charging Your Battery
Your Charger
Your phone was packaged with
either a rapid or travel charger. It is
important that you fully charge
your battery before you use your
phone. Both chargers supply
power to charge your battery while
the battery is attached to your
phone. If your phone is On, it can
receive calls while using either
charger.
Note! Never attach the charger to a
phone that does not have a battery
installed.
 If you have a rapid charger, plug the charger into a
standard wall electrical outlet. If you have a travel
charger, connect the appropriate AC power cord and
phone charging cord to the travel charger.
 Hold the phone with the display and keypad facing
up.
 Hold the small plug on the charger cord so the light-
ning bolt symbol ( ) is up.
Getting Started