Grass Valley 8964ENC v.1.2.2 - Manual (Page 60)

60 8964ENC/-FS — Instruction Manual
Configuration
When no Restore upon Install checkboxes on any of the media module Slot
Config web pages are selected and the Always Slot Refresh checkbox on the
8900NET Configuration web page is unchecked, the slot refresh polling
function on the 8900NET module will be disabled. See the
Always Slot Refresh
checkbox description in the 8900NET (Net Card) Network Interface Module
Instruction Manual for more details.
Note Uncheck the Restore Upon Install button before downloading new software.
Frame Health Reporting
This web page allows configuration of the alarms and warnings that are
reported to the external Frame Health Alarm connector on the rear of the
GeckoFlex frame. Refer to 8900NET Instruction Manual for more details.
LED Reports
This link appears when the 8900NET module has software version 4.0.2 or
later installed. When the link is selected, a read-only status report of the
8900NET Hardware Switch state is given. In the LED Reporting section of
the web page, LED Reporting can be enabled or disabled as desired.
SNMP Trap Reports
Select the SNMP Trap Reports link to open the 8900NET SNMP Reporting
web page. This link will only be present when SNMP Agent software, such
as NetCentral, has been installed on the 8900NET module. This web page
allows configuration of which alarms and warnings that are reported to the
SNMP management software.
Refer to 8900NET Instruction Manual for more details on the links to the
8900NET module.