Grass Valley 3e Student CameraMan - Manual (Page 18)

Chapter 2
12 CameraMan 1-CCD and 3-CCD Student Camera System Installation and Operations
Relay contact closure would connect to a video
switcher.
To Connect the Audio, or Video Relay:
1. Connect one end of a 2-conductor cable to the
green connector block:
• Strip a short section (approximately 0.15”)
off the end of the wire
• Insert the wire into the AUDIO RELAY or
VIDEO RELAY screw terminal slot on the
connector block to the far right (the positive
“+” lead is on top, the negative “-” lead is
on the bottom
• Tighten the terminal screw
2. Connect the other end of the cable to your audio
equipment per their instructions.