EverFocus ENVS1600 - Manual (Page 14)

ENVS800 / ENVS1600 / ENVS3200 Installation Manual
14 of 115
5.3 Quick Start Setup
This chapter describes the minimum installation steps to install IP-cameras for standard
(continuous) recording.
Note: This quick start setup is based on the premise that all IP cameras in the system are
installed in the same network and IP-address range as the NVR. The default IP -
setting of the NVR is DHCP mode. If there is no DHCP host on the LAN, a static IP
configuration must be assigned using Windows.
1. Register your camera license serial number(s) (Internet connection required; for
alternate methods see Appendix 9 Online License Procedures.)
A. Open “License Manager” Tool. Click CONFIG -> License Manager
B. Select “On line” as Activate type.
C. Input the “SN (Serial number)”, and then click on “Activate” button.
D. Main Console will be restarted if activated successfully.