Grass Valley JSC-2300 SHOT - Manual (Page 37)

Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual 37
Section
3
Installation and Setup
Note Refer to Controls and Indicators on page 21 to learn the SHOT Director™
controls and indicators functions before starting this setup procedure.
Note To make selections and enter information, the following procedures use the
joystick as a pointing device (joystick for movement and joystick top button
as a mouse-type left click) and the Camera and Preset keypad. Instead of
using the joystick, the MANUAL IRIS and FOCUS CONTROL knobs can also
be used during setup to select various setup parameters.
Installation and setup consists of:
• Install SHOT Director Controller on page 38
• Unpack on page 38
• Connect to Network on page 38
• Connect Power Supply on page 38
• Power On on page 39
• Setup SHOT Director Controller on page 39
• Adjust LCD Dialog Box on page 39
• Calibrate Joystick on page 39
• Set Audible Alarm (Optional) on page 42
• Reassign Camera Quick Select Buttons (Optional) on page 42
• Reset SHOT Director Defaults (Optional) on page 43
• Change Pan/Tilt IP Table Entries (Optional) on page 43
• Setup SDC/HDC Robotic Camera on page 44
• Set Camera ID and IP Address on page 44
• Set Pan and Tilt Orientation on page 46
• Set Pan/Tilt Soft Stops on page 46
• Set Camera Video Characteristics on page 48