Getkaudiooutvolume – Grass Valley Kaleido Remote Control Protocol Gateway Jan.09 2014 User Manual

Page 25

Advertising
background image

21

Kaleido Remote Control Protocol (Gateway)

User’s Guide

•

999.999.999.999

is the IP address of the device from where the stream occurs.

•

XX

is the identifier of the feed to use.

• To select an Audio Bridge Terminal (ABT) source, format the command as follows:

<setKAudioOut>set Type="AUDIOCARD" Input="999"</setKAudioOut>

Where

999

represents the ABT input number. ABT input numbers 1–64 are associated

with the SDTI IN (or ABT/MADI) connector on your multiviewer’s INPUT A card; numbers
65-128 to the connector on INPUT B, etc.

• To select an embedded source, format the command as follows:

<setKAudioOut>set Type="EMBEDDED" Input="AAA" Group="BB"
AES="X"</setKAudioOut>

Where:

•

AAA

indicates the video input.

•

BB

indicates the group. Valid values range from 1 to 4.

•

X

indicates the AES. Value can be either 1 or 2.

• To stop audio monitoring and mute the audio output:

<setKAudioOut>set Type="NONE"</setKAudioOut>

Gateway response:

•

<ack/>

: The command was correctly interpreted.

•

<nack/>

: The command was not executed, due to wrong spelling or an invalid

parameter.

getKAudioOutVolume

KX K2 AQ

This command retrieves the current volume at the analog audio monitoring output.

<getKAudioOutVolume/>

Gateway response:

• <kAudioOutVolume>volume="XX"</kAudioOutVolume>

Where

XX

is the value, expressed in dB, at which the audio monitoring volume is set.

This value ranges between 96 dB and +24 dB for a Kaleido-X series multiviewer, and
between 90 dB and 0 dB for a Kaleido-K2/Alto/Quad/Quad-Dual. Fractions of dB are
supported on the Kaleido-X series multiviewers only.

•

<nack/>

: The command was not recognized.

Notes

• To use this command with a Kaleido-X series multiviewer, you must first

open a session with user privilege validation (see

openID

), otherwise the

gateway will return

<nack/>

.

• The KMV-3901/3911, and Kaleido-IP do not support this command.

Advertising
This manual is related to the following products: