Grass Valley PLSDST3 - Manual (Page 13)

Installing the RAM
DST 312/412 Interface Kit Installation 7
2. Unplug the SCSI cables from the top edge connectors on the Master EDR
board. The SCSI cable locations are shown in Figure 4.
NOTE: If the tape system is to be connected to SCSI D, the Slave EDR board
must have 64 MB of RAM installed. In cases where a tape drive is to be
connected to SCSI B and another to SCSI D, both EDR boards must have
64 MB of RAM.
Figure 4. Locating the SCSI cables
0169-6
SCSI A
SCSI C
Slave EDR Board
Master EDR Board
SCSI B
SCSI D