Grass Valley Profile Analog Composite Monitor - Manual (Page 14)

Monitor Board Installation
14 Analog Composite Monitor Installation
Removing Hold-downs
There are two hold-down brackets located in the circuit board area that must be
removed in order to remove and replace circuit boards. Figure 2 shows these
brackets.
To remove the hold-down brackets:
1. Use the Torx tool with the T10 tip to remove the screw (
Ê
in Figure 2) which
secures the rear board hold-down.
2. Lift the hold-down (
Ë
in Figure 2) up and out of the chassis and set aside.
3. Use the Torx tool with the T10 tip to remove the screw (
Ì
in Figure 2) which
secures the front board hold-down.
4. Lift the hold-down (
Í
in Figure 2) up and out of the chassis and set aside.