Grass Valley Profile Analog Composite Monitor - Manual (Page 26)

Monitor Board Installation
26 Analog Composite Monitor Installation
Example 2
If you next want to install an Analog Composite I/O board:
1. From the Board I/O Requirements and Restrictions table, note that the
Analog Composite I/O board requires 2 inputs and 2 outputs and that the first
recommended slot is J14 and the second recommended slot is J15, with slots
J11, J5, and J7 as other possibilities.
2. Looking at your Board Location Chart, you see that slot J11 is open.
3. On your Board Location Chart:
- Put Xs in the J11 Input blocks 1 and 2.
- Put Xs in the J11 Output blocks 1 and 2.
4. Write Analog Composite I/O in the Board column for slot J11 and install
the board.
Your Board Location Chart would then look similar to Table 4: Example 2.