Polaris 2000 Universal Snowmobile - Manual (Page 102)

97
MAINTENANCE
Wear Strips
Most models come from the fac-
tory with tunnel wear strips or
wear strip coolers installed.
Check your specification sup-
plement to see if your model has
wearstrips. These wear strips
are designed for a specific stud
length. See your dealer’s stud-
ding chart for recommended
traction accessories.
CAUTION:
Use of studs greater than 1″ (2.5
cm) on machines equipped with
center coolers will result in cen-
ter cooler damage.
Whenever wear strips are relo-
cated, check to be sure there is
adequate stud clearance to the
heat exchangers. Without prop-
er clearance damage to heat
exchangers will result.
Wear strip
mounting
holes
Top of Tunnel
Wear Strip
Track
View from rear of track
Forward