Polaris 2016 600 Rush PRO-S - Manual (Page 72)

70
THE PERFECT FIT
Handlebar Component Fastener Torques
Component Torque
Do not over-tighten
IMPORTANT: Moving a handlebar component without first loosening its
screws/set screws may cut grooves into the handlebar, making it difficult
to secure the component. Do not move a handlebar component without
first loosening its mounting screws/set screws.
Take care to avoid damaging hand warmer/brake switch wires when
moving components.
1. Left Handlebar Control Block 20 in-lbs (2.3 Nm)
2. Brake Lever / Master Cylinder
Torque the front screw first, then torque
the screw next to the reservoir. 70 in-lbs (7.9 Nm)
3. Upper / Lower Riser Clamps 14.8 ft-lbs (20 Nm)
4. Throttle Lever Block Set Screw 27 in-lbs (3.1 Nm)
5. Throttle Lever Block Cover Screws 6 in-lbs (0.7 Nm)
6. Auxiliary Engine Stop Switch Set Screw 12 in-lbs (1.4 Nm)
7. Riser Install with the “FWD”
stamp facing forward,
toward the hood.
Hand Guard Mounts (if applicable) Hand-Tight
2
1
3
4/5
6 7
3
Shown with riser cover removed for clarity