Polaris 2014 Ranger 400 - Manual (Page 29)

27
FEATURES AND CONTROLS
Seat Removal
Pull up on the front of the seat and slide it toward the front of the vehicle.
Install the seat by sliding the tabs into the rear of the seat base. Push down firmly on the front
of the seat until the pins are fully seated into the grommets.
Cab Nets
Riding in this vehicle without using the cab nets (or doors, if equipped) increases the risk of
serious injury or death in the event of an accident or rollover. Cab nets (or doors) must be
used by both operator and passengers at all times. Make sure all latches are secure before
operating the vehicle.
Always inspect cab nets and latches for tightness, wear and damage before each use of the
vehicle. Use the strap adjusters to tighten any loose straps. Promptly replace worn or
damaged cab nets and latches with new cab nets and latches. Please see your authorized
POLARIS dealer.
Securing a Net
1. After entering the vehicle, insert the lower net rod into the net mount on the floor. Make
sure the ball at the end of the rod is properly secured in the slot at the base of the mount.
2. Connect the latch at the top edge of the net to the receiver latch mounted on the front
frame.
Opening a Net
1. To exit the vehicle, release the top front latch.
2. Rotate the net rearward and slide the lower net rod out of the mount to remove it.
3. Allow the net to hang freely outside the vehicle while dismounting.
Net Rod
Top
Latch
Rod Mount Net Rod