Polaris 2014 Ranger 400 - Manual (Page 80)

78
MAINTENANCE
Battery
Battery Removal
Improperly connecting or disconnecting battery cables can result in an explosion and cause serious
injury or death. When removing the battery, always disconnect the negative (black) cable first. When
reinstalling the battery, always connect the negative (black) cable last.
1. Remove the seat.
2. On conventional batteries, remove the battery vent
tube.
3. Disconnect the black (-) battery cable first.
4. Disconnect the red (+) battery cable last.
5. Lift the battery out of the vehicle. Be careful not to
tip a conventional battery sideways, which could
spill electrolyte.
NOTICE: If electrolyte spills, immediately wash it off with a
solution of one tablespoon baking soda and one cup
water to prevent damage to the vehicle.
Battery Installation
Using a new battery that has not been fully charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance. Always install a fully charged battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
3. With conventional batteries, install the battery vent tube (sealed batteries do not have a
vent tube). The vent tube must be free of obstructions and securely installed. Route the
tube away from the frame and vehicle body to prevent contact with electrolyte.
WARNING! Battery gases could accumulate in an improperly installed vent tube and cause an
explosion, resulting in serious injury or death. Always ensure that the vent tube is free of obstructions
and is securely installed as recommended.
4. Coat the terminals with dielectric grease or petroleum jelly.
5. Connect and tighten the red positive (+) cable first.
6. Connect and tighten the black negative (-) cable last.
7. Verify that cables are properly routed. Cables should be safely tucked away at the front
and rear of the battery.
8. Install the battery hold-down strap.
WARNING
Battery