Emerson Guided Wave Radar Level and Interface Transmitters 3300 - Manual (Page 27)

Reference Manual
00809-0100-4811, Rev CA
February 2006
3-3
Rosemount 3300 Series
INSTALLATION
PROCEDURE Follow these steps for proper installation:
NOTE!
Disconnect power supply before setting the Write Protection.
Review Installation
Considerations
(see page 3-6)
Check switches for
4-20 mA AlarmOutput
(see page 3-4)
Mount the transmitter
(see page 3-13)
Wire the transmitter
(see page 3-21)
Make sure covers
and cable/conduit
connections are
tight.
Power Up the
transmitter
Configure the
transmitter
(see page 4-1)
Verify measurements
Set the Write
Protection Switch