Key commands, Ii – 5 d a ta int e rf ace – HEIDENHAIN ND 287 User Manual User Manual
Page 106
106
II Installation, specifications
II – 5 D
a
ta int
e
rf
ace
External operation via RS-232-C/V.24 or USB
interface
Key commands
You can operate the ND 287 remotely over the RS-232-C/V.24 (X31) or
USB (UART, X32) data interface using an external device. The
following key commands are available:
Format
<ESC>TXXXX<CR>
Key is pressed
<ESC>AXXXX<CR>
Output of screen contents
<ESC>FXXXX<CR>
Execute function
<ESC>SXXXX<CR>
Execute special function
Sequence of commands
Function
<ESC>T0000<CR>
Key '0'
<ESC>T0001<CR>
Key '1'
<ESC>T0002<CR>
Key '2'
<ESC>T0003<CR>
Key '3'
<ESC>T0004<CR>
Key '4'
<ESC>T0005<CR>
Key '5'
<ESC>T0006<CR>
Key '6'
<ESC>T0007<CR>
Key '7'
<ESC>T0008<CR>
Key '8'
<ESC>T0009<CR>
Key '9'
<ESC>T0100<CR>
CLEAR key
<ESC>T0101<CR>
Key '–'
<ESC>T0102<CR>
Key '.'
<ESC>T0103<CR>
Navigation key
<ESC>T0104<CR>
Key 'ENTER'
<ESC>T0105<CR>
Key 'Cursor Up'
<ESC>T0106<CR>
Key 'Cursor Down'
<ESC>T0107<CR>
Key 'Soft key 1' (left)
<ESC>T0108<CR>
Key 'Soft key 2'
<ESC>T0109<CR>
Key 'Soft key 3'
<ESC>T0110<CR>
Key 'Soft key 4' (right)