HEIDENHAIN TNC 320 (340 55x-03) - Manual (Page 464)

464 11 Test Run and Program Run
1
1
.6 A
u
to
matic Pr
ogr
am Star
t
11.6 Automatic Program Start
Function
In a Program Run operating mode, you can use the AUTOSTART soft
key (see figure at upper right) to define a specific time at which the
program that is currently active in this operating mode is to be started:
 Show the window for entering the starting time (see
figure at center right).
 Time (h:min:sec): Time of day at which the program
is to be started.
 Date (DD.MM.YYYY): Date at which the program is to
be started.
 To activate the start, select OK
The TNC must be specially prepared by the machine tool
builder for use of the automatic program start function.
Refer to your machine manual.
CAUTION—danger to life!
The autostart function must not be used on machines that
do not have an enclosed working space.