HEIDENHAIN TNC 320 (340 55x-03) Touch Probe Cycles - Manual (Page 56)

56
3.1 Measur
ing W
o
rk
piece Misalignment
Setting a BASIC ROTATION (touch probe
cycle 404, DIN/ISO: G404)
With touch probe cycle 404, you can set any basic rotation
automatically during program run. This cycle is intended primarily for
resetting a previous basic rotation.
8 Preset value for basic rotation: Angular value at
which the basic rotation is to be set.
Example: NC blocks
5 TCH PROBE 404 BASIC ROTATION
Q307=+0 ;PRESET BASIC ROTATION