6 optional block skip, Function, Erasing the “/” character – HEIDENHAIN iTNC 530 (340 420) ISO programming User Manual
Page 435: 6 optional bloc k skip 11.6 optional block skip
Advertising
HEIDENHAIN iTNC 530
435
1
1
.6 Optional bloc
k skip
11.6 Optional block skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
U
U
U
U
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
U
U
U
U
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
Erasing the “/” character
U
U
U
U
In the Programming and Editing mode you select the block in which
the character is to be erased.
U
U
U
U
Erase the “/” character.
This function does not work for G99 blocks.
After a power interruption the control returns to the most
recently selected setting.
Advertising