Setting datum points using holes/cylindrical studs, 4 set ting the d a tu m with a 3-d t o uc h pr obe – HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles User Manual

Page 41

Advertising
Setting datum points using holes/cylindrical studs, 4 set ting the d a tu m with a 3-d t o uc h pr obe | HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles User Manual | Page 41 / 191 Setting datum points using holes/cylindrical studs, 4 set ting the d a tu m with a 3-d t o uc h pr obe | HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles User Manual | Page 41 / 191
Advertising
This manual is related to the following products:
See also other documents in the category HEIDENHAIN Equipment: