HEIDENHAIN iTNC 530 (340 49x-05) - Manual (Page 305)

HEIDENHAIN iTNC 530 305
9.8 A
d
ditional F
unctions
FN 20: WAIT FOR: NC and PLC synchronization
With function FN 20: WAIT FOR you can synchronize the NC and PLC
with each other during a program run. The NC stops machining until
the condition that you have programmed in the FN 20 block is fulfilled.
The TNC can check the following PLC operands:
This function may only be used with the permission of
your machine tool builder.
PLC operand Abbreviation Address range
Marker N 0 to 4999
Input I 0 to 31, 128 to 152
64 to 126 (first PL 401 B)
192 to 254 (second PL 401 B)
Output O 0 to 30
32 to 62 (first PL 401 B)
64 to 94 (second PL 401 B)
Counter C 48 to 79
Timer ING 0 to 95
Byte B 0 to 4095
Word W 0 to 2047
Double word D 2048 to 4095