SMA SB 3300-11 - Manual (Page 12)

Display SMA Solar Technology AG
12 SB33_38-BA-BEN114230 User Manual
4 Display
4.1 Operation
The display shows the current values of your plant. The displayed values are updated every
5 seconds.
You can operate the display by tapping the enclosure lid:
Single tap:
The backlight is switched on. After 2 minutes, the backlight switches off.
2 taps in quick succession (valid from firmware version 4.00):
The inverter successively displays the device type, the firmware version and the configured country
setting.
4.2 Display Messages during Operation
After commissioning, the inverter successively displays the device type, the firmware version and the
configured country setting. If you want to view the display messages of the startup phase again while
the inverter is in operation, double tap the enclosure lid (from firmware version 4.00).
Upon error-free connection of the inverter to the power distribution grid, after approximately one
minute, the display starts alternating between the messages shown below. Each message appears for
5 seconds, and then the cycle restarts from the beginning.
Display message Description
Inverter device type
Firmware version of internal processors
Default national standard of inverter, example:
"GER/VDE0126-1-1"
SB xxx
Wrxxx