Yaskawa CM051 - Manual

DWG. NO. 02Y00025-0387
SHEET NO. 1 OF 4
R E L . 5 / 7 / 9 6
( m - df )
For GPD 333
Adjustable Frequency Drives
CHANGE RECORD
DEVICENET SATELLITE
MODEL CM051
NOTE
This option may have been installed by the factory. However, certain steps can
only be completed at the installation site. Therefore, review and then perform
those steps which will complete the installation process.
CAUTION
Before installing this option, a TECHNICALLY QUALIFIED INDIVIDUAL who is
familiar with this type of equipment and the hazards involved, should READ THIS
ENTIRE INSTRUCTION SHEET.
CAUTION
The DeviceNet Satellite board is an electrostatic sensitive device. Personnel must
use approved methods for handling this type of equipment.
WARNING
HAZARDOUS VOLTAGE CAN CAUSE SEVERE INJURY OR
DEATH. ENSURE ALL POWER SOURCES FEEDING DRIVE
ARE LOCKED IN THE "OFF" POSITION BEFORE INSTALLING
THIS OPTION.
INTRODUCTION
The DeviceNet network is a low-cost communications network used to connect industrial devices (such as limit
switches, photoelectric switches, valve manifolds, motor starters, smart motor controllers, operator interfaces,
and variable frequency drives) as well as control devices (such as programmable controllers and computers).
The DeviceNet network can accommodate up to 64 nodes per network. A GPD 333 appears as one node on the
network. A DeviceNet Satellite board (MagneTek part no. CM051) must be installed into each GPD 333 drive that
will be communicating on the DeviceNet network. The GPD 333 DeviceNet Satellite resides on the front of the
drive in the location normally used by the status plate or the Digital Operator. The Satellite board is powered from
both the 24VDC DeviceNet network power and the GPD 333 drive that it is connected to.