JBL Synthesis K2 S9900 - Manual (Page 21)

Project K2 S9900
21
CHAPTER 3
Unpacking the Project K2 S9900 System
All components of the K2 S9900 system have been very carefully packed
for maximum protection against damage. As with any superior audio product,
it is advisable to keep the original packing materials, in case it is necessary
to transport the Project K2 S9900 system. Because of the bulk and weight of
this loudspeaker, it is recommended that at least two people unpack it in the
following manner. Stainless-steel round feet are installed on the bottom of the
speaker cabinet. In order to avoid damage to the floor, unpacking on a well-
protected surface, such as a thick carpet or cardboard, is strongly advised.
(Your loudspeaker system is packed with protective wrapping, but this is
omitted in drawings below.)
I. With a knife, carefully cut the tape securing the carton. Tape cutting is
required on only three of the four sides of the front flap.
II. Open the flaps and remove the two side filler sleeves by pulling them straight
forward.
III. Step on the lower flap and carefully rock the system and packing back and
forth. Pull outward while doing this, and the system and packing can be “walked”
out of the carton. It helps to have a second person hold the carton steady from
the back side.
I. II. III.