Laney IRT-STUDIO - Manual (Page 22)

22
USB
Optional Speaker Load
iPad/MAC/PC
Recording Device
IRT-Studio
FX
FX
USB
Optional Speaker Load
iPad/MAC/PC
Recording Device
IRT-Studio
Proceed as for normal “Re-Amping” except in this case
insert your FX box/s into the Guitar lead from the Re-
Amp out jack to the Guitar amplifier input. The recorded
Left channel will contain the original unprocessed signal
now with your effects only added. The right channel will
contain the same sound but also processed via the
Studio amplifier.
IRT Studio USB “Re-Amping”
with added Stomp box Effects:
Set up in a similar manner to “Re-Amping”, except return
the signal lead from the “Re-Amp” jack to the FX return
Jack on the rear panel. (Set the FX switch to 0dB). Then
proceed as for Re-Amping except this time only the
Dynamics/Tone and Reverb controls will be operative.
This can be run with or without a speaker connected with
different results.
IRT Studio USB Tube “Output Stage Warming”:
(If a speaker is connected then the 15W high output option can be initiated by inserting an unconnected jack
plug into the 15W front panel jack).
(It should be noted that without a speaker connected the amplifier always defaults to <1W operation
regardless of which input jack is used)
TIP
TIP
USB INTERFACE FOR PC, MAC & IPAD