Laney L5-STUDIO - Manual (Page 9)

Rear Panel Controls Continued
9
DI: Sourced from either pre or post output section and can be used with or without a speaker load. This connector provides
balanced direct feed primarily go to a PA sound desk. It carries an adjacent ground lift switch to remove any hum loop
problems. To allow suitable levels to be sent to the desk there is also a+4dB/-30dB send level switch.
EMULATION: This provides continuous 4x12 cabinet emulation to the Phones and switchable emulation for USB and the
D.I. output.
USB: A standard USB 2.0 audio in/out connector is provided for recording purposes.
For further explanation of USB and associated controls, see page 11.
PHONES: A stereo jack is provided which can be used for headphones or a stereo feed to a PA system. A Source switch
allows you to listen to the full amplifier or stereo return from the USB. A level control is included for comfortable listening.
Ensure the Phones level is turned to minimum before connecting headphones to avoid unexpected levels.
AUXILIARY INPUT: This input allows the connection of backing tracks (or any line level audio signal) to be mixed in post
FX loop.
TIP