Laney VC15-110 User Manual
Page 13
4
5
8
6
7
EFFECTS LOOP: SEND/LINE OUT: Connect the input of your external effect to this socket. All of the signal leaves
the amplifier via the `Send’ socket to be processed and comes back from the effects via the `Return` socket. This socket
can also be used to control another VC15 amplifier connected to this socket via its own return socket. Some Effects are
better suited to being between the guitar and amplifer input - these are foot pedal types / distortion / wah wah pedals etc.
Rack mount effects will work better in the FX loop on the amplifer rear. Stomp boxes are normally designed for small
signals such as a guitar output whereas rack mount FX are designed for the higher signal level obtained from an FX send.
This socket can also be used as a Line Level Out.
BY-PASS/LEVEL SWITCH: This switch allows the effects loop to be by-passed if not in use, it also gives you the option
of running the FX loop at 0dB (750mV) or at -10dB (250mV) to suit your processor.
EFFECTS LOOP: RETURN: Connect the output from your external effects to this socket. The effects loop allows you
to connect external effects such as tremolo’s, chorus and delays to your amplifier. All of the signal leaves the amplifier via
the `Send’ socket and comes back from the effects via the `Return` socket. Use the output level control on your FX to
control how loud the FX return signal sounds. This is an insert type control, therefore you need to set the Dry/ Wet mix in
your FX processor.
FOOTSWITCH SOCKET: Provided for the connection of a Laney FS2 footswitch (optional) .This allows you to
remotely switch between the clean/drive channel and & switch the built in reverb On/Off.
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will
reduce the amplifiers performance and in some cases may cause damage to your amplifier. Try the VC15-110 into a Laney
extension cabinet - you will be amazed what this little baby cranks out. Note: When an external speaker cabinet is
connected it disconnects the onboard loudspeaker
SERIAL NO: Displays the model and serial number of the unit.
9