Laney LX120RH User Manual
Page 14
SAMPLE SYSTEM
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish
and follow a pattern for turning on and off your equipment. With all system
parts connected, turn on source equipment, tape decks, cd players, mixers,
effects processors etc. BEFORE turning on your guitar amplifier. Many products
have large transient surges at turn on and off which can cause damage to your
speakers. By turning on your guitar amplifier LAST and making sure its Volume
controls are set to minimum any transients from other equipment will not reach
your loudspeakers. Wait until all system parts have stabilised; usually a couple of
seconds. Similarly when turning off your system always turn down the Volume
controls on your guitar amplifier and then turn off its power before turning off
other equipment.
Cables: never use shielded or microphone cable for any speaker connections
as this will not be substantial enough to handle the amplifier load and could
cause damage to your amplifier system.
Caution: These professional loudspeaker systems are capable of generating
very high sound pressure levels. Use care
with placement and operation to avoid
exposure to excessive levels that can
cause permanent hearing damage. (Refer
to guidelines on page 2)
Servicing: The user should not attempt
to service these products. Refer all
servicing to qualified service personnel.
L
Z
B
1
2
3
4
L
Z
B
1
2
3
4
14