Laney AH40 - Manual (Page 12)

AH40/AH80 REAR PANEL
(AH80 SHOWN. AH40 SIMILAR)
18. VOLTAGE SELECT SWITCH This is factory set to the correct voltage for the region the product is supplied to. If necessary it can be reset by
removing the mains lead and then loosening (but not removing) the screws securing the cover. The cover can then be pivoted away from the switch which
can be moved to select the alternate voltage. DO NOT reconnect the mains lead until the cover is replaced and secured. Please ensure the correct fuse is
fitted (as printed on the panel) for the voltage being used.
19. MAINS INLET SOCKET Connect to your power source using the supplied cable.
20. MAINS FUSE This drawer contains the main safety fuse for the unit. USE ONLY THE CORRECT SIZE AND RATING SPECIFIED ON THE PANEL.
21. MAINS POWER SWITCH When turned on, the Power LED on the front panel will light.
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your equipment. With all
system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc. BEFORE turning on your AUDIOHUB.
Many products have large transient surges at turn on and off which can cause damage to your speakers. By turning on your AUDIOHUB LAST and
making sure its Volume control is set to minimum any transients from other equipment will not reach your loudspeakers. Wait until all system
parts have stabilised; usually a couple of seconds. Similarly when turning off your system always turn down the Volume control on your
AUDIOHUB and then turn off its power before turning off other equipment.
Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with placement and
operation to avoid exposure to excessive levels that can cause permanent hearing damage. (Refer to guidelines on page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.