Laney IRT-X User Manual

Page 9

Advertising
background image

1. MAINS INLET SOCKET: IEC input for connection of an appropriate mains lead.
Make sure the voltage indicated on the voltage selection switch is correct for your
country!

2. MAINS SWITCH: Turns the system on and off. Ensure the level controls are
at minimum when switching on and off.

3. Voltage Selection Switch: This is factory set to the correct voltage for the
region the product is supplied to. If necessary it can be reset by removing the
mains lead and then loosening (but not removing) the screws securing the cover.
The cover can then be pivoted away from the switch which can be moved to
select the alternate voltage. DO NOT reconnect the mains lead until the cover is
replaced and secured.

EQ CONTROLS: On Board EQ. Consisting of:
4. Active Bass control allowing boost and cut of the low-frequency response of
the pre-amplifier. To give optimum levels adjust gain till the peak LED just illumi-
nates on the very loudest passages.
5. Active Treble control allowing boost or cut of the high frequency response of
the pre-amplifier.
6. MASTER VOLUME: Controls the overall level of the IRT-X
7. CLIP LED: Illuminates just before the amplifier begins to clip and distort.
Adjust the level controls and signal level from your source so this illuminates only
briefly on peaks in the music. Using the system with this LED on all or much of
the time will result in poor sound quality and possible damage to speakers and
electronics.

8. POWER LED: This will illuminate when the power switch is operated,
indicating that mains power is within the amplifier.

9 INFORMATION: Area relating to the amplifier: Serial Number, operational
information, power rating, etc

PANEL CONTROLS

(Always switch off and disconnect the power cord when not in use)

8

Advertising