Lanner FW-6432 - Manual (Page 12)

9
Motherboard Information
Chapter 3
Network Application Platforms
Front Panel Reset Switch (SW_RST_BTN1): This switch
can be a hardware or software reset depending on
the BIOS setting.
DC 12V power input (J3)
Internal VGA Pin Header (VGAB1)
Ethernet ports 4~1(LANB1~LANB4)
LED1 LED2
Status Description Status Description
Off No Link Off 10 Mb Connection
On Linked Green 100 Mb Connection
Blinking Data Activity Amber 1 Gb Connection
Ethernet 1 and Ethernet 2 Port : These RJ45 gigabit
Ethernet ports are provided by Realtek RTL8111E GbE
controller. The major feature of this controller is the
Energy Efficient Ethernet (EEE). The EEE works with
MAC layer to support operation in Low Power Idle
mode. Some of the key capabilities are listed below:
Integrated 10/100/1000 transceiver •
Auto-Negotiation with Next Page capability •
Supports PCI Express 1.1 •
Supports pair swap/polarity/skew correction •
Crossover Detection & Auto-Correction •
Wake-on-LAN and remote wake-up support •
Microsoft NDIS5, NDIS6 Checksum Offload (IPv4, IPv6, •
TCP, UDP) and Segmentation Task-offload (Large send
v1 and Large send v2) support
Supports Full Duplex flow control (IEEE 802.3x)
•
Supports jumbo frame to 9K bytes •
Fully compliant with IEEE 802.3, IEEE 802.3u, IEEE •
802.3ab
Supports IEEE 802.1P Layer 2 Priority Encoding
•
Supports IEEE 802.1Q VLAN tagging •
Supports IEEE 802.3az Draft 3.0 (EEE) •
Pin No. Function
1 RSt_BtN
2 GND
3 4
1 2
Pin No. Function
1 +12V
2 GND
PIN NO. Function PIN NO. Function
1 R 2 Ground
3 G 4 Ground
5 B 6 Ground
7 H-SYNC 8 Ground
9 V-SYNC 10 Ground
11 Detect-display
Data
12 Deteck-display
CLOCK
2
4
6
8
10
12
1
3
5
7
9
11
PIN NO. Function
1 BI_DA+
2 BI_DA-
3 BI_DB+
4 BI_DC+
5 BI_DC-
6 BI_DB-
7 BI_DD+
8 BI_DD-
LED1 LED2