Bang & Olufsen BeoVision 10 Getting Started - Manual (Page 27)

In
st
al
la
tio
n a
nd
s
et
ting
up
Calibrate the speakers
If you have speakers in your setup, set up the
speakers to optimise sound from your listening
position.
Calibrate the stand
Set the maximum angle the TV will turn – left and
right. The motorised movement of the TV will not
work until the calibration process has been
completed. You can only tilt the TV manually.
First-time setup of loudspeakers applies only to speakers for TV viewing.
See the Guide for further information.
Adjust volume, bass, treble and loudness and preset two default speaker
combinations. Select a different speaker combination at any time.
At ‘SET LEFTMOST
POSITION’ turn left to the
point you wish to restrict
the movement to
At ‘SET RIGHTMOST
POSITION’ turn right to the
point you wish to restrict the
movement to
Accept
Set preferred preset position for the TV to turn to, when it is switched
on and off.
NOTE! You need to calibrate the stand before you
can use the motorised movement of the stand. Power saving
2 *Speaker settings
If you have other equipment connected to your television, set POWER
SAVING to OFF. See the Guide for further information.
The menus SPEAKER DISTANCE and SPEAKER LEVEL are only available on
BeoVision 10-40/46.
STAND POSITIONS
SPEAKER TYPE
SPEAKER DISTANCE*
2
SPEAKER LEVEL* 2
ADJUSTMENT
STAND ADJUSTMENT
27