Logitek Electronic Systems Artisan - Manual (Page 12)

Logitek
3
Physical Installation
3 Physical Installation
The Artisan surface is designed to be mounted in a desk cutout in a permanent studio or control
booth installation.
A PC flat-screen is mounted behind the console. The mounting arrangements for this will depend
on the screen purchased and studio furniture.
The optional low-profile Meter Bridge can be screwed to the desk or mounted to the Artisan frame
using the supplied mounting brackets and screws.
Power Supply Unit
The Power Supply Unit is a 2-RU sized rack mount box, designed for mounting in an under-desk
studio rack. If the supplied 10’ (3m) cables are not long enough to allow for convenient mounting,
custom length cables are readily available.
The Power Supply is suitable for mounting in a studio environment and has been designed to be
silent. The modules are a low-noise type and all electronics are solid-state (no mechanical relays).
The Power Supply contains two switch-mode supply modules, with a power indicator for each
module on the front panel.
Power inlet is via a single IEC connector on the rear of the Power Supply Unit. A power cable is
supplied only for US installations. International customers may contact their reseller for the supply
of power cables if required.
As the power supply modules are of switch-mode type, there is no voltage selection required.
Artisan Frames
A number of Artisan frame sizes are available, depending on the total number of faders and control
modules. Each module takes up either one, two or four “slots” in the frame. The Master module
takes four slots. The Fader, Monitor, Effects and Wide Softkey modules take two slots. The Narrow
Softkey
and Blank Panel take up one slot.
The frame will be shipped with the modules connected and fitted as ordered. These modules can
be moved if desired. If moving modules, please retain the same internal COM port connections as
the surface shipped with. If the COM port connections are changed, the device addressing for those
modules will change.
Logitek Artisan Reference Manual 10