Logitek Electronic Systems Artisan - Manual (Page 30)

Logitek
5
Operation
Artisan Control Modules
MTK-MON (Monitor Module)
See the following page for more information on the Artisan monitor screen.
Use the TB IN knob to increase or decrease the level of Talkback Return.
The SLATE button sends the Talkback Mic to all Master, Sub-master and
Aux
busses for recording of slate audio.
These four buttons control the operation of the Control Room monitors.
Select either of 5.1 (Surround Sound), Stereo, Mono or Mute.
Turn the SELECT knob to select the source for the Switched Meter. Press
the knob to take the source.
The CNG button enters/cancels the select menu.
Turn the PFL/SOLO knob to adjust the gain for PFL to the cue speaker.
Toggle the MON button to switch PFL between the cue speaker and the
Control Room monitors. When PFL is routed to monitors, gain is adjusted
by the Control Room pot and not the PFL/SOLO pot.
Busses on SOLO are always routed to the Control Room monitors.
Four OFFLINE SOURCE buttons allow quick access to commonly used
sources to be sent to the Mix Minus outputs when the console is “offline”.
Use the MIX- OFFLINE button below to toggle the Mix Minus outputs on
or offline. This feature can also be GPI controlled from an on-air tally.
XLR jack for gooseneck Talkback Mic.
Studio 1 , Studio 2, Control Room gain, source, talkback and control:
Use the knob to adjust the gain, indicated by the Ring of Fire LEDs.
Press CNG, then rotate the knob to select from available input sources.
Press CNG again to take the selected source.
Use the DIM buttons to toggle a pre-set reduction in monitoring level.
Four SOURCE buttons allow quick access to commonly used sources.
The LCD screen displays the current source and level for each output.
Use the MUTE buttons to mute the monitoring output.
Use the TB buttons as a push-to-talk to break talkback into each of the
monitor outputs.
Use the TB OUT knob to increase or decrease the Talkback Mic level.
Four DIRECT TB buttons allow quick access to commonly used intercom
destinations. Push-to-talk and Hold-lock are support. Press the CONF
button to talk to all DIRECT TB destinations simultaneously. Press MUTE
to toggle the Talkback Mic muting.
Logitek Artisan Reference Manual 28