Epson POWERLITE 5010E - Manual (Page 41)

Making Detailed Adjustments
41
■ Gamma
You can select from five gamma settings (2.0 to 2.4) or customize your own setting from
your image or a displayed graph. Lower values will increase the contrast of dark areas, but
tend to blur the bright areas. Higher values will darken the light areas. See page 31 for
more information.
3D Setup
Use the options in the 3D Setup menu to adjust 3D brightness, the 3D display format and
other 3D settings.
Note: You should only adjust the 3D Format and Inverse 3D Glasses settings if 3D images aren’t
displaying correctly. Changing these settings unnecessarily may cause problems with 3D
projection.
■ 3D Display
Enables or disables 3D mode. You can also change this setting by pressing the 2D/3D
button on the remote control.
■ 2D-to-3D Conversion
Enable this setting to convert 2D images into 3D content.
■ 3D Format
Use this setting to select the 3D format supported by your video device. In most cases, the
projector will correctly detect the 3D format when this option is set to
Auto . You should
only select the 2D , Side by Side , or Top and Bottom formats when your projector
doesn’t properly display 3D images. See your video source documentation for
information on which mode to select.
■ 3D Depth
Adjusts the depth of the 3D images. Select the Medium or Strong settings to increase
the appearance of the 3D effect.
Note: This setting is only available when using the 2D-to-3D Conversion feature.
Image > Advanced > Gamma
Signal > 3D Setup > 3D Display
Signal > 3D Setup > 2D-to-3D Conversion
Signal > 3D Setup > 3D Format
Signal > 3D Setup > 3D Depth