Epson POWERLITE 5010E - Manual (Page 66)

66
Maintenance
10. Tighten the lamp cover screw.
11. Reset the lamp usage timer, as described on page 66.
Resetting the Lamp Usage Timer
After replacing the lamp, plug the projector back in, turn on the power switch on the back of
the projector, and press the Ppower button on the projector or the
On button on the remote
control. Then follow these steps to reset the lamp usage timer:
1. Press the Menu button on the projector or remote control.
2. Use the menu navigation buttons to open the Reset menu, then select Reset Lamp
Hours .
3. When you see a confirmation prompt, highlight Yes and press the Enter button.
4. When you’re finished, press the Menu button to exit.
The lamp usage timer shows 0H until you’ve used the lamp for at least 10 hours.
Checking the Projector Status
You can use the Info menu to view information about the current display settings and how
long the projection lamp has been in use. To access the Info menu:
1. Press the Menu button on the projector or remote control.