Enterasys Networks 6H2xx - Manual (Page 139)

General Configuration Screen
Module Configuration Menu Screens 5-13
5.2.7 Setting the Module Time
To set the switch module time, perform the following steps:
1. Use the arrow keys to highlight the Module Time field.
2. Enter the time in this 24-hour format: HH:MM:SS
3. Press ENTER to set the system clock to the time in the input field.
4. Use the arrow keys to highlight the SAVE command at the bottom of the screen and press
ENTER.
If the time entered is a valid format, the message displays “SAVED OK” at the top of the screen. If
the entry is not valid, Local Management does not alter the current value and refreshes the Module
Time field with the previous value.
5.2.8 Entering a New Screen Refresh Time
The screen refresh time can be set from 3 to 99 seconds with a default of 3 seconds. To set a new
screen refresh time, perform the following steps:
1. Use the arrow keys to highlight the Screen Refresh Time field.
2. Enter a number from 3 to 99.
3. Press ENTER to set the refresh time to the time entered in the input field.
4. Use the arrow keys to highlight the SAVE command at the bottom of the screen and press
ENTER.
If the time entered is within the 3 to 99 seconds range, the message “SAVED OK” displays at the
top of the screen. If the entry is not valid, Local Management does not alter the current setting, but
it does refresh the Screen Refresh Time field with the previous value.
NOTE: If the 6C105 or 6C107 chassis has been assigned a chassis time, it is not
necessary to assign a module time to the switch module. All installed modules recognize
the chassis time.
NOTE: When entering the time in the system time field, separators between hours,
minutes, and seconds are not needed as long as each entry uses two numeric
characters. For example, to set the time to 6:45 P.M., type “184500” in the Module Time
field.