Extron electronic MVX 88 Series - Manual (Page 70)

Remote Operation, cont’d
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Remote Operation 4-20
PRELIMINAR
Y
Mute-output settings — Displays the RGB Delay/Mute/Output-Volume Adjust
window (figure 4-13), which allows you to mute and unmute the video
and audio output for a single output or for all outputs. This window also
displays the RGB delay and output volume level settings and allows you to
change them.
Update firmware — Allows you to replace the firmware that is coded on the
switcher’s control board without taking the switcher out of service, opening
the switcher enclosure, and replacing the firmware chip set.
See “Updating the firmware” on page 4-16.
Name presets — Allows you to name each of the 16 memory presets.
Show RS-232 strings — Displays the ASCII commands that are used by the current
configuration. You can refer to these for RS-232 programming.
Initialize — Initializes and clears any or all of the following: ties, presets, RGB
delay, audio configuration, preset titles, icon names, and icons.
Audio-input Configuration selection — Displays the Configure Audio Options
window (figure 4-14), which shows the audio gain level settings for each
input and allows you to change them.
Preferences menu
Immediate changes — Causes changes to take effect
immediately.
Hold/verify changes — Delays implementation of changes
until the Changes – Take button is pressed.
Ties as lines — Displays ties as lines (figure 4-15).
Figure 4-15 — Ties shown as lines